Entries tagged with “plaster”.


Living in the NW, stucco is not as prevalent, compared to other areas of the US, as a building material. I finally got the opportunity to perform air monitoring for silica during stucco crack repair. From what the contractor explained, only the top layer of stucco (1/8 inch) is removed. He claimed the top layer is mostly an acrylic. The employee was wearing a 1/2 face tight fitting respirator with P100 (HEPA) cartridges. In addition, engineering controls were used.  The contractor had a grinder with a shroud and vacuum to remove the dust. This would not be considered a worse-case sampling scenario. From conversations with the plasterer-employees onsite, grinding is usually “VERY dusty”.

Sampling performed only for the duration of the grinding (3 hours). Conclusion?: We did not find any detectable levels of silica or respirable dust.

Please don’t use this sampling as the only information on how to proceed for your project. However, here are my observations:

  • If acrylic material is the top 1/4 inch, you may not impact silica (or have any airborne).
  • Airborne dust was very well controlled by grinder with shroud & vacuum (see pic below).
  • Assume you will have dust until you can observe (or prove) otherwise. Wear a respirator.
  • Perception is huge. If there is a big dust cloud coming from your grinder—even if there’s no silica… the observers don’t know the difference, and, well,…you know the story.

 

This blog-post is directed to employees….the drywall framers, hangers, tapers, fireproofers & plasteres who sand and finish mud & drywall.

Question: What type of respirator do you wear when you sand?

…answer? Anything I can find.

This question misleading… and is similar to the one where the attorney asks in divorce court, “Do you beat your wife only when you’re drunk, or all the time?”

But, reiterate.  Do you ever NOT wear a respirator when sanding?  Answer: No. We always wear a respirator. It’s dusty.

So if I may ask a leading question (as a bad attorney): What type of respirator would you wear if you were worried about OVERexposure?

Answer: a tight fitting 1/2 face (or full face, for eye protection & fogging control) negative pressure respirator with HEPA cartridges.

I think I’ve made my point. Why would you choose a paper dust mask? The fit is mediocre, they are disposable, you cannot fit test them (very well). Who cares if it’s a N95 or P100. You can feel the dust escaping around your nose. Below are some “average” pictures of people sanding. What will you do?   more info here