Industrial Hygiene in Construction

There are only a few instances when you are not required to perform fit testing. The main reason not to perform fit testing is if the employees are wearing a respirator voluntary. (meaning: it’s not required)

So, how do you know if it’s required? It’s required when:

• You have overexposures to a substance (it’s required by OSHA to wear a respirator- so make sure you know, perform air monitoring), or
• If everyone is wearing a respirator during this task (it’s probably also required, just not formally- ie. spray finishing, or my favorite sanding drywall dust) or,
• If your company policy requires them to be worn (management says: it’s required to wearing a respirator during this task).

So, if you choose voluntary to wear a respirator and there is NOT a policy, or law, that says you HAVE to wear one then, you don’t need fit testing. (but you do need a few other things, Appendix D, etc.)

There is only one other exception:

• loose fitting hooded /helmet atmosphere supply respirators (when used in areas not immediately dangerous to life and health (IDLH))

Some employers choose to use these types of respirators because:

• the employee wears a beard
• it is convenient to use
• offers eye/face/neck protection
• it offers a greater protection factor
• it’s easier to don/doff (take on/off)

These guidelines for fit testing are different than medial testing before wearing a respirator, as spoken about here.

There are two types of fit testing, 1. quantitative and, 2. qualitative. For quantitative fit testing you’ll need a machine (ex. Portacount),  a respirator that will protect more than 50x the limits (>full face).  I will not cover this type of fit testing in this post, but it is very similar.

For qualitative fit testing you will need:

A medical clearance (not needed if you are wearing a paper dust mask) for each employee wearing a respirator.

Respirator w/P-100 filters (1/2 face respirator or more protective), aka HEPA filters, purple in color.

fit test kit -your choices are: saccharine, irritant smoke, Bitrex, or isoamyl acetate-bananas. Buy it online, or at your local safety supplier. Look at their instructions.

My preference is to use irritant smoke. The reasons are;

1.  if they cough, it means they smelled it.
2. it doesn’t require a containment to be built to perform the fit testing.

The employee must be clean shaven around where the mask touches the face.  I allow “short” goaties where the facial hair does not touch the mask. The fit test procedures are easy to follow and found inside the kit. There are 8-steps, do each one for about 1 minute each.

As you fill out each individual’s form, make sure you include:

• if the employee is clean shaven
• what type of respirator is being worn (size, brand, model)
• what type of filters are being worn
• what type of fit test kit you used

While you have the employee captive, you might as well give them some training. Here are some questions and/or points to note.

• did you train them on positive & negative fit checks?
• why are they wearing a respirator?
• what are the limitations of their respirator?
• how will they store the respirator?
• how will they sanitize it?
• will they share their respirator?

Finally, sign and date the form. It expires one year from this date. Simple? yes.  Easy to forget something? yes.